Table of Contents
Advertisement
Chapter 5
Setup and Configuration
NOTE
Letters in MAC addresses must be lowercase.
switch mac-tables static-mac-table static-mac address vlan
Where:
• address is the Unicast MAC address that is to be statically configured. It can have up to 6 '*' wildcard
characters continuously applied from the right.
• vlan is the ID of the VLAN upon which the MAC address operates.
3.
Configure the following parameter(s) as required:
Parameter
learned
slot { slot }
port { port }
cos { cos }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.35.4.3
Deleting a Static MAC Address
To delete a static MAC address, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the static MAC address by the typing:
no switch mac-tables static-mac-table static-mac address vlan
Where:
• address is the Unicast MAC address that is to be statically configured. It can have up to 6 '*' wildcard
characters continuously applied from the right.
• vlan is the ID of the VLAN upon which the MAC address operates.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.36
Managing Spanning Tree Protocol
The following sections describe how to configure and manage STP:
512
Description
Synopsis: typeless
If set, the system will auto-learn the port upon which the device
with this address is located.
The name of the module location provided on the silkscreen
across the top of the device.
The selected ports on the module installed in the indicated slot.
Synopsis: { N/A, normal, medium, high, crit }
Default: normal
The priority of traffic for a specified address.
RUGGEDCOM ROX II
CLI User Guide
Deleting a Static MAC Address
Advertisement
Table of Contents
Troubleshooting
