Deleting A Virtual Switch; Managing Virtual Switch Interfaces - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
Parameter
forward-delay { forward-delay }
alias { alias }
ip-address-src { ip-address-src }
proxyarp
4. Add one or more interfaces for the virtual switch. For more information, refer to
Virtual Switch Interface".
5. [Optional] Assign one or more VLANs to the virtual switch. For more information, refer to
"Adding a Virtual Switch
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
6.
Section 3.24.3

Deleting a Virtual Switch

To delete a virtual switch, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the chosen switch by typing:
no interface virtualswitch name
Where:
• name is the name assigned to the virtual switch
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 3.24.4

Managing Virtual Switch Interfaces

The following sections describe how to configure and manage virtual switch interfaces:
• Section 3.24.4.1, "Viewing a List of Virtual Switch Interfaces"
• Section 3.24.4.2, "Adding a Virtual Switch Interface"
• Section 3.24.4.3, "Deleting a Virtual Switch Interface"
Deleting a Virtual Switch
VLAN".
Description
Retain IP on bridge device.
Default: 15
Delay (in seconds) of the listening and learning state before goes
to forwarding state.
Synopsis: A string 1 to 64 characters long
The SNMP alias name of the interface
Synopsis: { static, dynamic }
Default: static
Whether the IP address is static or dynamically assigned via
DHCP or BOOTP.
Synopsis: typeless
Enables/Disables whether the port will respond to ARP requests
for hosts other than itself
Device Management
Section 3.24.4.2, "Adding a
Section 5.37.7.2,
Chapter 3
147