Configuring Vlans For Switch Ethernet Ports - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
.
.
.
The VLANs listed are based on the PVIDs assigned to the switched Ethernet ports. For more information about
assigning PVIDs to switched Ethernet Ports, refer to
Section 5.37.3.2

Configuring VLANs for Switch Ethernet Ports

When a VLAN ID is assigned to a switched Ethernet port, the VLAN appears in the All-VLANs Table where it can
be further configured.
To configure a VLAN for a switched Ethernet port, do the following:
1. Make sure the CLI is in Configuration mode.
2. Navigate to switch » vlans » all-vlans » {id}, where {id} is the ID of the VLAN and configure the following
parameter(s) as needed:
Parameter
ip-address-src { ip-address-src }
proxyarp
on-demand
mtu { mtu }
3. Add Quality of Service (QoS) maps to the VLAN. For more information, refer to
QoS Map".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
550
lm3 none
lm4 none
lm5 none
lm6 none
0 0
1 0
2 0
3 0
4 0
Section 3.17.2, "Configuring a Switched Ethernet
Description
Synopsis: { static, dynamic }
Whether the IP address is static or dynamically assigned via
Dynamic Host Configuration Protocol (DHCP) or Bootstrap
Protocol (BOOTP). The DYNAMIC option is a common case of
a dynamically assigned IP address. It switches between BOOTP
and DHCP until it gets the response from the relevant server.
This must be static for non-management interfaces.
Synopsis: typeless
Enables/Disables whether the VLAN will respond to ARP
requests for hosts other than itself.
Synopsis: typeless
Brings up this interface on demand only.
Synopsis: An integer between 68 and 1500
Default: 1500
The maximum transmission unit (the largest packet size allowed
for this interface).
Section 5.39.7.2, "Adding a
Configuring VLANs for Switch Ethernet Ports
RUGGEDCOM ROX II
CLI User Guide
Port".