Managing Static Multicast Groups; Viewing A List Of Static Multicast Groups; Adding A Static Multicast Group - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
2. Enable static multicast routing by typing:
routing multicast static enable
Configure the following parameter(s) as required:
Parameter
enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.24.2

Managing Static Multicast Groups

The following sections describe how to configure and manage static multicast groups:
• Section 5.24.2.1, "Viewing a List of Static Multicast Groups"
• Section 5.24.2.2, "Adding a Static Multicast Group"
• Section 5.24.2.3, "Deleting a Static Multicast Group"
Section 5.24.2.1

Viewing a List of Static Multicast Groups

To view a list of static multicast groups, type:
show running-config routing multicast static
If static multicast groups have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config routing multicast static | tab
routing multicast static enabled
routing multicast static mcast-groups
DESCRIPTION SOURCE IP
---------------------------------------------------------------------------
test.001 169.150.24.12
If no static multicast groups have been configured, add groups as needed. For more information about adding
static multicast groups, refer to
Section 5.24.2.2

Adding a Static Multicast Group

To add a static multicast group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the multicast group by typing:
410
MULTICAST IN
IP INTERFACE
238.1.12.12 switch.0001
Section 5.24.2.2, "Adding a Static Multicast
Description
Synopsis: typeless
Enables static multicast routing service
Prerequisite: Dynamic and static multicast routing can not be
enabled together.
HW
ACCELERATE IFNAME
- fe-cm-1
Group".
RUGGEDCOM ROX II
CLI User Guide
Managing Static Multicast Groups