Managing Hosts; Viewing A List Of Hosts; Adding A Host - Siemens RUGGEDCOM ROX II User Manual

Hide thumbs Also See for RUGGEDCOM ROX II:

Table of Contents

RUGGEDCOM ROX II

CLI User Guide

Section 5.17.10

Managing Hosts

Hosts are used to assign zones to individual hosts or subnets (if the interface supports multiple subnets). This

allows the firewall to receive a packet and then redirect it to the same device that received it. This functionality is

useful for VPN setups to handle the VPN traffic separately from the other traffic on the interface which carries the

VPN traffic.

Table: Example

The following sections describe how to configure and manage hosts for a firewall:

Section 5.17.10.1, "Viewing a List of Hosts"

Section 5.17.10.2, "Adding a Host"

Section 5.17.10.3, "Deleting a Host"

Section 5.17.10.1

To view a list of hosts, type:

show running-config security firewall fwconfig firewall fwhost

• firewall is the name of the firewall

If hosts have been configured, a table or list similar to the following example appears:

ruggedcom# show running-config security firewall fwconfig firewall1 fwhost

fwconfig firewall1

fwhost host1

interface fe-cm-1

no ipaddress

no description

If no hosts have been configured, add hosts as needed. For more information, refer to

Section 5.17.10.2

To add a new host for a firewall, do the following:

Managing Hosts

Setup and Configuration

IP Address or Network

192.168.0.0/24

Section 5.17.10.2, "Adding

Rx1500 Rx1512 Rx1501 Rx1510 Rx1511