Viewing A List Of Ip Multicast Groups; Managing Vrrp - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
Parameter
Section 5.26.7

Viewing a List of IP Multicast Groups

To view a list of all multicast groups, type:
show switch mcast-filtering ip-mcast-groups
If IP multicast groups have been configured, a table or list similar to the following example appears:
ruggedcom# show switch mcast-filtering ip-mcast-groups
IP
VID ADDRESS MAC
-------------------------------------------------------------------
100 225.0.1.1 01:00:5e:00:01:01
200 225.0.1.2 01:00:5e:00:01:02
This table or list provides the following information:
Parameter
vid
ip-address
mac
Joined Slot
Joined Ports
Router Slot
Router Ports
Section 5.27

Managing VRRP

The Virtual Router Redundancy Protocol is a gateway redundancy protocol. VRRP provides a gateway failover
mechanism that is invisible to the hosts and other devices that send traffic through that gateway. The Virtual
Router Redundancy Protocol (VRRP) eliminates a single point of failure associated with statically routed
networks by providing automatic failover using alternate routers. The RUGGEDCOM ROX II VRRP daemon
432
Description
The multicast group MAC address.
JOINED JOINED ROUTER
SLOT PORTS SLOT
lm1 3
lm1
lm1 4
lm1
Description
The VLAN Identifier of the VLAN upon which the multicast group
operates.
Synopsis: A string
The multicast group IP address.
Synopsis: A string
The multicast MAC address corresponding to the group multicast IP
address.
The name of the module location provided on the silkscreen across
the top of the device.
The selected ports on the module installed in the indicated slot.
The name of the module location provided on the silkscreen across
the top of the device.
The selected ports on the module installed in the indicated slot.
ROUTER
PORTS
1
2
Viewing a List of IP Multicast Groups
RUGGEDCOM ROX II
CLI User Guide