Adding A Static Arp Table Entry; Deleting A Static Arp Table Entry - Siemens RUGGEDCOM ROX II User Manual

RUGGEDCOM ROX II
CLI User Guide
192.11.0.4 00:11:94:11:00:03
192.11.0.5 00:11:94:11:00:04
192.11.0.6 00:11:94:11:00:05
If no ARP table entries have been configured, add static ARP table entries as needed. For more information
about adding static ARP table entries, refer to
Section 5.33.3.2

Adding a Static ARP Table Entry

To add a static ARP table entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the table entry by typing:
switch layer3-switching arp-table address
Where:
• address is the IP address for the network device the entry describes
3. Configure the following parameter(s) as required:
NOTE
Letters in MAC addresses must be lowercase.
Parameter
mac { mac }
vid { vid }
status
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 5.33.3.3

Deleting a Static ARP Table Entry

To delete a static ARP table entry, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the key by typing:
Adding a Static ARP Table Entry
4084
4084
4084
Section 5.33.3.2, "Adding a Static ARP Table
Description
Synopsis: A string
Default: 00:00:00:00:00:00
The MAC address of the network device specified by the IP
address.
Synopsis: An integer between 1 and 4094
The VLAN Identifier of the VLAN upon which the MAC address
operates.
Synopsis: { resolved, unresolved }
Default: unresolved
Address Resolution Protocol (ARP) entry resolution status:
<itemizedlist><listitem>Resolved: The MAC-IP address pair
is resolved and operational.</listitem> <listitem>Unresolved:
The device hasn't resolved the MAC-IP address pair and keeps
sending ARP requests periodically.</listitem></itemizedlist>
Chapter 5
Setup and Configuration
Entry".
501