Table of Contents
Advertisement
RUGGEDCOM ROX II
CLI User Guide
hardware Ethernet 00:01:c0:0b:b7:70;
}
lease 192.168.0.8 {
starts 2 2012/11/13 20:38:47;
ends 2 2012/11/13 20:48:47;
hardware Ethernet 00:01:c0:0c:8b:a3;
client-hostname "ape2-PC";
}
lease 192.168.0.22 {
starts 2 2012/11/13 20:36:14;
ends 2 2012/11/13 20:46:14;
hardware Ethernet 00:01:c0:0b:b7:71;
}
Section 5.15.5
Managing DHCP Listen Interfaces
DHCP listen interfaces specify the IP interface to which the client sends a request.
The following sections describe how to manage DHCP listen interfaces:
•
Section 5.15.5.1, "Viewing a List of DHCP Listen Interfaces"
•
Section 5.15.5.2, "Adding a DHCP Listen Interface"
•
Section 5.15.5.3, "Deleting a DHCP Listen Interface"
Section 5.15.5.1
Viewing a List of DHCP Listen Interfaces
To view a list of DHCP listen interfaces, type:
show running-config services dhcpserver interface
If DHCP listen interfaces have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config services dhcpserver interface | tab
NAME
-------------
switch.0001
!
!
If no DHCP listen interfaces have been configured, add interfaces as needed. For more information, refer to
Section 5.15.5.2, "Adding a DHCP Listen
Section 5.15.5.2
Adding a DHCP Listen Interface
To add a DHCP listen interface, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the interface by typing:
Managing DHCP Listen Interfaces
Interface".
Chapter 5
Setup and Configuration
239
Advertisement
Table of Contents
Troubleshooting
