Chapter 5
Setup and Configuration
ruggedcom# show running-config switch mcast-filtering igmp-snooping router-ports | tab
SLOT
PORT
------------
lm1
1
!
!
If no router ports have been configured, add ports as needed. For more information, refer to
"Adding a Router
Port".
Section 5.26.3.3
Adding a Router Port
To add a router port for IGMP snooping, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the router port by typing:
switch mcast-filtering igmp-snooping router-ports slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.26.3.4
Deleting a Router Port
To delete a router port for IGMP snooping, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the router port by typing:
no switch mcast-filtering igmp-snooping router-ports slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.26.4
Managing the Static Multicast Group Table
The following sections describe how to configure and manage a list of known static multicast groups on other
devices:
•
Section 5.26.4.1, "Viewing a List of Static Multicast Group Entries"
•
Section 5.26.4.2, "Adding a Static Multicast Group Entry"
428
RUGGEDCOM ROX II
CLI User Guide
Section 5.26.3.3,
Adding a Router Port