Managing Ipv4 Addresses; Viewing A List Of Ipv4 Addresses - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
errors 0
dropped 0
transmit
bytes 0
packets 0
errors 0
dropped 0
collisions 0
interfaces ip fe-cm-1
.
.
.
This table or list displays the following information:
Parameter
admin-state
state
pointopoint
bytes
packets
errors
dropped
bytes
packets
errors
dropped
collisions
Section 5.40.3

Managing IPv4 Addresses

The following sections describe how to configure and manage IPv4 addresses:
• Section 5.40.3.1, "Viewing a List of IPv4 Addresses"
• Section 5.40.3.2, "Adding an IPv4 Address"
• Section 5.40.3.3, "Deleting an IPv4 Address"
Section 5.40.3.1

Viewing a List of IPv4 Addresses

To view a list of IPv4 address for a routable interface, type:
592
Description
Synopsis: { not set, up, down, testing, unknown, dormant, notPresent, lowerLayerDown }
The port's administrative status.
Synopsis: { not set, up, down, testing, unknown, dormant, notPresent, lowerLayerDown }
Shows whether the link is up or down.
Synopsis: true or false
The point-to-point link.
The number of bytes received.
The number of packets received.
The number of error packets received.
The number of packets dropped by the receiving device.
The number of bytes transmitted.
The number of packets transmitted.
The number of error packets transmitted.
The number of packets dropped by the transmitting device.
The number of collisions detected on the port.
RUGGEDCOM ROX II
CLI User Guide
Managing IPv4 Addresses