Adding A Host Group; Configuring Host Group Options - Siemens RUGGEDCOM ROX II User Manual

Chapter 5
Setup and Configuration
no nis server
no nis domain
!
!
!
!
!
If no host groups have been configured, add host groups as needed. For more information, refer to
Section 5.15.11.2, "Adding a Host
Section 5.15.11.2

Adding a Host Group

To add a host group to the DHCP server, do the following:
1. Make sure the CLI is in Configuration mode.
2. Configure the following parameter(s) as required:
Parameter
{ name }
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 5.15.11.3

Configuring Host Group Options

To configure options for a host group on the DHCP server, do the following:
NOTE
Options set at the host group level override options set at the DHCP server level.
1. Make sure the CLI is in Configuration mode.
2. Navigate to services » dhcpserver » host-groups » {host} » options, where {host} is the name of the host
group.
3. Configure the following parameter(s) as required:
Parameter
unknown-client { unknown-client }
shared-network { shared-network }
subnet { subnet }
default { default }
maximum { maximum }
254
Group".
Description
Synopsis: A string 1 to 32 characters long
The description of the host groups.
Description
Synopsis: { allow, deny, ignore }
Default: allow
The action to take for previously unregistered clients.
The shared network that this host group belongs to.
The subnet that this host group belongs to.
Default: 600
The minimum leased time in seconds that the server offers to the client.
Default: 7200
RUGGEDCOM ROX II
CLI User Guide
Adding a Host Group