Adding An Ethernet Trunk Interface - Siemens RUGGEDCOM ROX II User Manual

Chapter 3
Device Management
!
!
If no Ethernet trunk interfaces have been configured, add trunks as needed. For more information, refer to
Section 3.21.2, "Adding an Ethernet Trunk
Section 3.21.2

Adding an Ethernet Trunk Interface

To add an Ethernet trunk interface, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the interface by typing:
interface trunks id
Where:
• id is the ID given to the trunk
3. Configure the interface by typing the following commands:
Parameter
switchport
on-demand
ip-address-src { ip-address-src }
proxyarp
mtu { mtu }
alias { alias }
4. Configure the multicast filtering settings by typing the following commands:
Parameter
gmrp { gmrp }
122
Interface".
Description
Synopsis: true or false
The physical port into either Switched mode or a dedicated
Routing mode.
Synopsis: typeless
Bring up this interface on-demand only
Synopsis: { static, dynamic }
Whether the IP address is static or dynamically assigned via
DHCP or BOOTP. Option DYNAMIC is a common case of a
dynamically assigned IP address. It switches between BOOTP
and DHCP until it gets the response from the relevant server.
This must be static for non-management interfaces.
Synopsis: typeless
Enables/Disables whether the VLAN will respond to ARP
requests for hosts other than itself
Synopsis: An integer between 68 and 1500
Default: 1500
Maximum transmission unit (largest packet size allowed for this
interface).
Synopsis: A string 1 to 64 characters long
The SNMP alias name of the interface
Description
Synopsis: { advertise_only, learn_advertise }
GMRP (GARP Multicast Registration Protocol) operation
on the port. There are several GMRP operation modes:
<itemizedlist><listitem>DISABLED : the port is not capable
of any GMRP processing.</listitem> <listitem>ADVERTISE
RUGGEDCOM ROX II
CLI User Guide
Adding an Ethernet Trunk Interface