Replacement Of Brake Resistor Bleeder - ABB IRC5 Product Manual

4 Repair activities, controller IRC5

4.26. Replacement of brake resistor bleeder

4.26. Replacement of brake resistor bleeder
Location
The illustration below shows the location of the brake resistor bleeder (behind the cover) in
the Single Cabinet Controller.
In the Dual Cabinet Controller the brake resistor bleeder is located in the Drive Module.
xx0500002022
A
Required equipment
Equipment
Brake resistor bleeder
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Circuit diagram
262
Brake resistor bleeder (behind plate, not visible).
Note
See Miscellaneous parts on page
The contents are defined in section
Standard toolkit
These procedures include references to the
tools required.
See Circuit Diagram on page
Continues on next page
3HAC021313-001 Revision: P
306.
319.