Cleaning Moist Dust Filter - ABB IRC5 Product Manual

3.4.2. Cleaning moist dust filter

Location
The moist dust filters are located as shown in the illustration below.
xx0700000128
A
B
C
D
Required equipment
Equipment
Cleaning agent
Compressed air
Cleaning
The procedure below details how to clean the moist dust filter.
3HAC021313-001 Revision: P
Moist dust filter magazine
Single Cabinet Controller
Dual Cabinet Controller, Control Module
Dual Cabinet Controller, Drive Module
Action
1. Remove the moist dust filter.
2. Clean the filter three or four times.
3. Allow the filter to dry in one of these ways:
• Lying flat on a flat surface
• Blow with compressed air in opposite
direction of filter airflow.
4. Refit the moist dust filter.
3 Maintenance activities, controller IRC5
3.4.2. Cleaning moist dust filter
Note
Water 30-40°C with cleansing liquid or detergent.
Note/Illustration
How to remove the moist dust filter is
detailed in section
dust filter on page
Do not wring the filter out!
How to refit the moist dust filter is
detailed in section
dust filter on page
Replacement of moist
171.
Replacement of moist
171.
175