Samsung DCS Programming Manual page 75

SAMSUNG DCS
TECHNICAL MANUAL
3e. Enter in desired selection from table "F" (e.g., 04)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
3f. Enter in desired selection from table "G" (e.g., 05)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
3g. Enter in desired selection from table "H" (e.g., 06)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
3h. Enter in desired selection from table "I" (e.g., 07)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
3i. Enter in desired selection from table "J" (e.g., 08)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
3j. Enter in desired selection from table "K" (e.g., 09)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
3k. Enter in desired selection from table "L" (e.g., 10)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor to step 4
4. Enter in desired selection from table "C"(e.g., 1)
OR
Press UP or DOWN key to make selection and press
LEFT soft key to move cursor back to step 3, and
continue entries
OR
Proceed to step 5
5. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
TABLE A
SIM PARAMETER
00 SIM TYPE
01 CALL MODE
02 ANS MODE
03 AUTO BAUD
= Table B
= Table C
= Table D
= Table E
PROGRAMMING
December 1996
[257] SIM PARA.
DTR CHECK:ON
[257] SIM PARA.
ECHO :ON
[257] SIM PARA.
PROTOCOL :V110
[257] SIM PARA.
SPEED :9600
[257] SIM PARA.
CHAR LENG:8 BITS
[257] SIM PARA.
PARITY :NONE
[257] SIM PARA.
STOP BIT :1
[257] SIM PARA.
CALL MODE:AWITH