Samsung DCS Programming Manual page 196

SAMSUNG DCS
TECHNICAL MANUAL
MMC: 725
DESCRIPTION:
Allows the system administrator to select the information printed on the SMDR report. The
following options may be selected to print on SMDR:
0. PAGE HEADER
1. LINE PER PAGE
2. INCOMING CALL
3. OUTGOING CALL
4. AUTHORIZE CODE
5. LESS START TIME
6. IN/OUT GROUP
7. DND CALL
8. WAKE-UP CALL
9. DIRECTORY NAME
10. CLIP
11. ABANDON CALL
The DIRECTORY NAME that appears on the SMDR header is programmed as follows:
Names are written using the keypad. Each press of a key will select a character. Pressing the next
key will move the cursor to the next position. For example, if the directory name is "SAM SMITH,"
press the number "7" three times to get the letter "S." Now press the number "2" once to get the
letter "A." Continue selecting characters from the table below to complete your message.
Pressing the bottom left programmable key will change the letter from upper case to lower case.
This option determines whether a page header will print at the
top of each page. This would normally be turned off if SMDR is
being sent to a call accounting machine.
This option selects the length of each page to determine when to
print the SMDR header. The number of lines may be in the range
01–99.
This option determines whether incoming calls will print on
SMDR.
This option determines whether outgoing calls will print on
SMDR.
This option determines whether authorization codes will print on
SMDR.
This option determines whether valid calls will include the
minimum call time in total call duration.
This option allows a message, IN GROUP or OUT GROUP, to be
printed in the Digits Dialed column each time a station enters or
leaves a group.
This option allows a message, IN DND or OUT DND, to be
printed in the Digits Dialed column each time a station enters or
leaves DND.
This option determines whether stations receiving an alarm
reminder call will print on SMDR.
This option allows the system administrator to enter a 16
character name which will appear on the SMDR header.
This option can be selected to print CLIP data received from the
C.O. on incoming ISDN calls. This option requires the use of a
132 column printer or an 80 column printer set for condensed
print.
If this option is set to YES unanswered calls will print on SMDR.
SMDR OPTIONS
PROGRAMMING
December 1996