Samsung DCS Programming Manual page 193

SAMSUNG DCS
TECHNICAL MANUAL
MMC: 724
DESCRIPTION:
Provide the access codes and dialing plan needed for operation of features and programs. The
system comes with a wide range of acceptable numbering plans set as default and the option to
customize the dialing plan. There is also an error message provided because of the chance of
duplicating an access/feature code. Dialing codes are entered via the dial pad key, by pressing
the dial pad number the required steps to select the feature. For example, for OHVA, the number
6 would be pressed three times. If Block Code is required, press 2 for the first letter B and then
use the UP or DOWN key to make the selection from BARGE to BLOCK.
NOTE: Please remember that this program is system-wide.
COUNT###
DIAL 2
DIAL 3
DIAL 4
DIAL 5
DIAL 6
DIAL 7
DIAL 8
DIAL 9
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
ACTION
1. Press TRSF
Display shows
2. Using the chart, press dial pad key
number to make selection
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
3. Enter in digits via the dial key pad (01-48)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
4. Enter in digits via the dial key pad
DIAL NUMBERING PLAN
DIAL KEY PAD
1
AAPLAY
DECT
GPIK
LCR
MMPA
PAGE
TG
WCOS
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
2 3
BARGE CAMP
DECT FAUTO
HLDPK IOG
LCR LCR
NEW OHVA
REJECT S0
UA
WCOS WCOS
DISPLAY
DIAL NUMBER PLAN
ACCT :47
DIAL NUMBER PLAN
DECT01 :7901→_
DIAL NUMBER PLAN
DECT01:7901→
DIAL NUMBER PLAN
DECT01:7901→8000
PROGRAMMING
December 1996
→