Samsung DCS Programming Manual page 38

SAMSUNG DCS
TECHNICAL MANUAL
MMC: 200
DESCRIPTION:
Used to open and close customer level programming. If programming is not opened and an
attempt is made to access a system MMC, the error message [NOT PERMIT] will be displayed. A
four digit passcode is required to access this MMC. Each digit can be 0–9. When opened, this
MMC enables access to all MMCs allowed in MMC 802 Customer Access MMC Number.
PROGRAM KEYS
UP & DOWN
KEYPAD
SPK
TRSF
ACTION
1. Press TRSF 200
Display shows
2. Enter passcode
Correct code shows
Incorrect code shows
3. Press UP or DOWN arrow key to
select ENABLE or DISABLE and
Press RIGHT soft key
OR
Dial 1 for ENABLE,dial 0 for DISABLE
4. Press SPK to advance to MMC entry level and press
UP or DOWN key to select MMC
Enter MMC number and press RIGHT soft
key to enter MMC.
5. To log out press TRSF key.
DEFAULT DATA: CLOSED
RELATED ITEMS: MMC 201 CHANGE CUSTOMER PASSCODE
OPEN CUSTOMER PROGRAMMING
Select open or closed
Used to enter passcode
Save data and advance to next MMC
Exit Programming
MMC 501 SYSTEM-WIDE TIMERS
MMC 802 CUSTOMER ACCESS MMC NUMBER
DISPLAY
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
DISABLE
ENABLE CUS.PROG.
PASSWORD ERROR
ENABLE CUS.PROG.
ENABLE
212:ALARM RING
OR SELECT PROG. ID
PROGRAMMING
December 1996