Samsung DCS Programming Manual page 142

SAMSUNG DCS
TECHNICAL MANUAL
MMC: 603
DESCRIPTION:
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is very
useful in the programming of LCR when more than one trunk is to be in several dialing plans.
There are two different modes of operation: (1) sequential and (2) distribute.
WARNING: As stated above, one trunk can appear in more than one trunk group. If necessary,
delete the trunk member from other groups to prevent accidental access.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
HOLD
ANS/RLS
ACTION
1. Press TRSF 603
Display shows
2. Enter in valid trunk group (e.g., 9, 80–89)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to advance cursor
3. Press RIGHT soft key to change mode
OR
Press UP or DOWN key to change mode to member
4. Press RIGHT soft key to move cursor to number of
member and enter valid member number (1–80, e.g., 05)
via dial key pad
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to move cursor
5. Enter valid trunk number (e.g., 729)
OR
Press UP or DOWN key to make selection and press
RIGHT soft key to return to step 2
6. Repeat steps 1–6 to remove trunk from group 9 if
necessary
7. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Used to clear previous entry
Used to select ALL
ASSIGN TRUNK GROUP
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MODE:SEQUENTIAL
[81] TRK GROUP
MEMBER 01:NONE
[81] TRK GROUP
MEMBER 05:NONE
[81] TRK GROUP
MEMBER 01:729
PROGRAMMING
December 1996