Connection With Hmi (Got) - Mitsubishi Electric MELSEC Q Series User Manual

7.6.4

Connection with HMI (GOT)

HMI (GOT) can be connected to the C Controller module as illustrated below.
• Connection via the Ethernet port
• Bus connection
• Connection via network modules
• MELSECNET/H, CMELSECNET/10 connection (PLC-to-PLC network)
• CC-Link IE Controller Network connection
• CC-Link IE Field Network connection
• CC-Link connection(intelligent device station, via G4)
Extension cable
For applicable GOT models, refer to the following.
 Connection manuals for GOT2000 series (Mitsubishi Electric Products), (Non-Mitsubishi Electric Products 1),
(Non-Mitsubishi Electric Products 2), (Microcomputer, MODBUS/Fieldbus Products, Peripherals)
 Connection manuals for GOT1000 series (Mitsubishi Electric Products), (Non-Mitsubishi Electric Products 1),
(Non-Mitsubishi Electric Products 2), (Microcomputer, MODBUS Products, Peripherals)
(1) Connection via the Ethernet port
Use the system Ethernet port (S CH1)/built-in Ethernet port (CH1 and CH2) for connection.
For wiring of the Ethernet cable, refer to the following.
Page 127, Section 8.7.2
C Controller
module
GOT
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
CHAPTER 7 SYSTEM CONFIGURATION
Network
module
Ethernet cable
Q12DCCPU-V
Each network
• MELSECNET/H
MELSECNET/10
• CC-Link IE Controller
Network
• CC-Link
(Intelligent device station,
via G4)
109
7