Q12Dccpu-V - Mitsubishi Electric MELSEC Q Series User Manual

2.2

Q12DCCPU-V

No. Name
1) Indicator LEDs
2) 7-segment LED
On
(green)
100M
Off
Built-in
On
3) Ethernet
(green)
port (CH1)
SD/RD Flash
(green)
Off
4) Built-in Ethernet port (CH2)
5) EJECT button
CompactFlash card installation
6)
slot
7) RUN/STOP/MODE switch
8) RESET/SELECT switch
9) USB connector
1) 5)
2)
6)
3)
4)
[ Front ]
Q12DCCPU-V
Page 43, (1) in this section.
Displays settings and results at the time of initialization and hardware diagnostics.
For the display during initialization, refer to the following.
Page 67, Section 6.1.2
For the display during hardware diagnostics, refer to the following.
Page 80, Section 6.5.2
Connecting at 100Mbps (automatically determined based on the target device)
Connecting at 10Mbps (automatically determined based on the target device)
Physical Ethernet connection detected
Data transmitting/receiving
Physical Ethernet connection not detected
The same as CH1.
Used to eject a CompactFlash card from a C Controller module.
Slot into which a CompactFlash card is installed.
RUN: Sets the C Controller module operation status to RUN.
STOP: Sets the C Controller module operation status to STOP.
MODE: Used for initialization and hardware diagnostics.
For usage during initialization, refer to the following.
Page 67, Section 6.1.2
For usage during hardware diagnostics, refer to the following.
Page 80, Section 6.5.2
RESET: Resets the C Controller module.(Page 71, Section 6.3)
SELECT: Unmount the CompactFlash card. (Page 122, Section 8.5)
Pull down each switch for at least 1 second for resetting or unmounting.
For usage during initialization, refer to the following.
Page 67, Section 6.1.2
For usage during hardware diagnostics, refer to the following.
Page 80, Section 6.5.2
USB connector used for connection with Setting/monitoring tool for the C Controller module.
7)
MODE STOP
RUN
RES.
SEL.
8)
9)
[ Front cover opened ]
Description
CHAPTER 2 PART NAMES
41
2