Mitsubishi Electric MELSEC Q Series User Manual page 58

Check field
Initial setting of modules
Set each module switch.
• Set the RUN/STOP/MODE switch on the C Controller module to STOP.
• Set the RUN/STOP/RESET switch on each CPU module to STOP.
• Set the intelligent Function module and network module switches.
System power-on
Power on after check that:
• power supply wiring is properly arranged.
• power supply voltage is within the operational range.
Parameter setting
Create a parameter.
• Set the parameters by Setting/monitoring tools for the C Controller
module.
• Connect the C Controller module and the development environment
(Personal computer).
(Use USB2 or S CH1. After initialization, the IP address is reset to the default.
To connect via the Ethernet, use the default IP address.)
• Write the parameters to the C Controller module.
C Controller system reset
Set the RUN/STOP/MODE switch on the C Controller module to RUN.
Reset the C Controller system.
Error check
Check for any error indicated by the C Controller module LEDs.
Perform troubleshooting if any error is present.
If any error is present in other than the C Controller module, refer to and
follow the manual for respective module(s) to perform troubleshooting.
User program creation
Create the user program.
• Install CW Workbench to the development environment (Personal
computer).
• Create a user program and script file(s).
• Connect the C Controller module and the development environment (Personal
computer). (Use CH1 or CH2.After initialization, the IP address is reset to the
default. To connect via the Ethernet, use the default IP address.)
• Register the user program to the C Controller module.
• Debug the user program.
56
From the previous page
Operation
$QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
$Manual for respective module
Page 35, CHAPTER 2
$QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
Page 288, CHAPTER 15
Page 111, Section 7.6.5
Page 129, Section 8.7.2 (3)
$Setting/Monitoring Tools for the C Controller
Module Version 4 Operating Manual
Page 71, Section 6.3
$Manual for respective module
Page 394, CHAPTER 23
Page 336, CHAPTER 19
Page 188, Section 11.10
Page 111, Section 7.6.5
Page 129, Section 8.7.2 (3)
$CW Workbench Operating Manual