Mitsubishi Electric MELSEC Q Series User Manual page 56

Check field
System power-on
Power on after check that:
• power supply wiring is properly arranged.
• power supply voltage is within the operational range.
Parameter setting
Create a parameter.
• Install Setting/monitoring tools for the C Controller module to the
development environment (Personal computer).
• Set the parameters by Setting/monitoring tools for the C Controller
module.
• Connect the C Controller module and the development environment
(Personal computer).
(Use USB2 or S CH1. After initialization, the IP address is reset to the
default. To connect via the Ethernet, use the default IP address.)
• Write the parameters to the C Controller module.
C Controller system reset
Set the RUN/STOP/MODE switch on the C Controller module to RUN.
Reset the C Controller system.
Error check
Check for any error indicated by the C Controller module LEDs.
Perform troubleshooting if any error is present.
If any error is present in other than the C Controller module, refer to and
follow the manual for respective module(s) to perform troubleshooting.
User program creation
Create the user program.
• Install CW Workbench to the development environment (Personal
computer).
• Create a user program and script file(s).
• Connect the C Controller module and the development environment
(Personal computer).(Use CH1 or CH2.After initialization, the IP
address is reset to the default. To connect via the Ethernet, use the
default IP address.)
• Register the user program to the C Controller module.
• Debug the user program.
54
From the previous page
Operation
$QCPU User's Manual
(Hardware Design, Maintenance and Inspection)
 Page 288, CHAPTER 15
 Page 111, Section 7.6.5
 Page 129, Section 8.7.2 (3)
$Setting/Monitoring Tools for the C Controller
Module Version 4 Operating Manual
 Page 71, Section 6.3
 Page 394, CHAPTER 23
$Manual for respective module
 Page 336, CHAPTER 19
 Page 111, Section 7.6.5
 Page 127, Section 8.7.2
$CW Workbench Operating Manual