Mitsubishi Electric MELSEC Q Series User Manual page 361

(2) Functions for compatibility
The following functions are for Q12DCCPU-V (Basic mode). Use them for utilizing user program(s) for
Q12DCCPU-V (Basic mode). To create a new user program, use the C Controller module dedicated function
(Page 353, CHAPTER 20) or the "Available functions" described in (1) above, instead of these functions.
Function name
QBF_ClearError
QBF_Control
QBF_Control7SegLED
QBF_Control7SegLED_ISR
QBF_ControlLED
QBF_ControlLED_ISR
QBF_EntryTimerEvent
QBF_EntryWDTInt
QBF_GetTime
QBF_MountCfCard
QBF_ReadSRAM
QBF_ReadSRAM_ISR
QBF_ReadStatusEx
QBF_RegistEventLog
QBF_ResetWDT
QBF_SetTime
QBF_StartWDT
QBF_StopWDT
QBF_UnmountCfCard
QBF_WaitTimerEvent
QBF_WriteSRAM
QBF_WriteSRAM_ISR
Remark
For importing of user program(s) for Q12DCCPU-V (Basic mode), refer to the following.
Page 465, Appendix 4
CHAPTER 21 PROGRAMMING USING BUS INTERFACE FUNCTIONS
Clears an error.
Controls remote RUN/STOP/PAUSE operations of the C Controller
module.
Controls the 7 segment LED of C Controller module.
Controls the 7 segment LED of C Controller module.
Controls USER LED of C Controller module.
Controls USER LED of C Controller module.
Registers timer events.
Registers a routine for the user WDT error interrupt.
Reads clock data.
Mounts a Memory card
Reads data from the battery backup RAM.
Reads data from battery backup RAM.
Reads the status information (LED, error, etc.) of C Controller module.
Registers event logs in the event history file.
Resets the user WDT.
Sets up clock data.
Sets an interval of WDT and starts up the user WDT.
Stops the user WDT.
Unmounts a Memory card.
Waits for an occurrence of a timer event.
Writes data to the battery backup RAM.
Writes data to battery backup RAM.
Function
: Supported : Not supported
CPU module
Q24DHC
Q12DC
-V
-V -VG

 

 




 
359
21