Mitsubishi Electric MELSEC Q Series User Manual page 114

(1) Connection to user program development environment, Personal computer for
maintenance, and superior control servers, etc.
The following personal computer can be connected using the user Ethernet port (CH1 and CH2)/built-in Ethernet
port (CH1 and CH2).
• User program development environment (CW Workbench and Wind River Workbench)
• Personal computer for maintenance (Telnet and FTP functions)
• Host communication network's superior control servers (MES server and SNTP server, etc.)
For wiring of the Ethernet cable, refer to the following.
Page 127, Section 8.7.2
Remark
● For the functions of user Ethernet port/built-in Ethernet port, refer to the following.
Page 192, Section 12.1
(2) Connection to Personal computer with Setting/monitoring tools for the C
Controller module installed
The following illustrates a sample case of connection with Setting/monitoring tools for the C Controller module.
For versions of Setting/monitoring tools for the C Controller module, refer to the following.
Page 52, CHAPTER 4
(a) Connection via USB connector
Use the USB connector for connection.
*1 : Use USB2 for Q24DHCCPU-V/-VG/-LS and Q26DHCCPU-LS.
For specifications and wiring of the USB cable, refer to the following.
Page 125, Section 8.7.1
Connection to USB connector is only possible from 1 Personal computer to 1 C Controller module.
112
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
*1
Q24DHCCPU-V/-VG/-LS
Q26DHCCPU-LS
For "-LS", consult with the
partner (operating system vendor).
Q12DCCPU-V
Q12DCCPU-V