15.2.2
Multiple CPU parameter importing
The following describes the procedure to utilize multiple CPU parameters set in another project.
For each setting screen and setting item, refer to the following.
Setting/Monitoring Tools for the C Controller Module Version 4 Operating Manual
(1) Operating procedure
The following is the procedure to import multiple CPU parameters set in another project.
1.
Start up the Setting/monitoring tools for the C Controller module.
2.
Create a project.
[Project] [New]
3.
Select a source project and read out I/O assignment and multiple CPU setting data.
Project view "Parameter" "CCPU Parameter"
<<I/O assignment settings>> / <<Multiple CPU settings>> "Import Multiple CPU Parameter"
4.
Use the same setting for Points Occupied by Empty Slot in all CPU modules.
Project view "Parameter" "CCPU Parameter" <<System settings>>
"Points Occupied by Empty Slot"
5.
Acknowledge details of <<I/O assignment settings>>.
Project view "Parameter" "CCPU Parameter" <<I/O assignment settings>>
Set the individual items that can be set in each CPU module for the multiple CPU system, as necessary.
Check that items with * in the setting screen are the same across all CPU modules.
6.
Acknowledge details of <<Multiple CPU settings>>.
Project view "Parameter" "CCPU Parameter" <<Multiple CPU settings>>
Set the individual items that can be set in each CPU module for the multiple CPU system, as necessary.
Check that items with * in the setting screen are the same across all CPU modules.
7.
Set parameters for other than multiple CPU system.
8.
Save a project.
[Project] [Save]
9.
Connect the PC to the C Controller module. (Page 125, Section 8.7)
10.
Write the parameters.
[Online] [Write to CCPU]
11.
Reset the C Controller system. (Page 71, Section 6.3)
The written parameters are applied.
CHAPTER 15 PARAMETER
295
15