ABB i-bus KNX Product Manual page 94

®
ABB i-bus KNX
Commissioning
Enable Group object
"Status switch"
Options:
Linked group object:
•
Yes: The (DALI output X) Status switch group object is enabled. It sends a 1-bit telegram on the KNX,
signaling the current switch status.
•
No: The status of the switch state is not actively sent on the KNX.
92 2CDC507164D0201 | DG/S x.64.1.1
Yes
No
Selection of Yes option:
Dependent parameters:
Send object value
Options: On change
On request
After a change or on request
•
On change: The status is sent when a change occurs.
•
On request: The status is sent when a request occurs.
•
After a change or on request: The status is sent when either a change or request occurs.
Status Switch