ABB i-bus KNX Product Manual page 145

®
ABB i-bus KNX
Commissioning
Parameter settings
Options:
This parameter defines whether the group/ballast settings are taken from the template or individually set.
•
•
The individual parameter windows and parameters are identical to those in the templates, therefore the
individual parameters are not covered separately here – please see X Functions template (group x/ballast
x) (Forced operation/Block/Burn-in/Partial failure), p.102.
Note
The minimal dimming value and maximum brightness value (dimming thresholds) set for the DALI
devices in the Ballast x and Group x parameter windows apply as basic settings for the ballast.
Certain of these thresholds are stored in the ballast and also apply to all functions. Therefore, when
setting the brightness value for the function, make sure that it is feasible given the basic ballast
settings.
Individual
Apply from template
Individual: The group/ballast is individually parametrized. Corresponding parameters for the
group/ballast are shown. The content of the individual parameters is the same as that in the
Functions template parameters.
Apply from template: The group/ballast takes its parameters from the Functions template.
DG/S x.64.1.1 | 2CDC507164D0201 143