ABB i-bus KNX Product Manual page 58

®
ABB i-bus KNX
Commissioning
Enable Group object
"Status switch addressed"
Options:
Linked group object:
•
Yes: The coded group object Status switch addressed is enabled. This coded 2-byte group object
(address plus status) sends the switching state of a ballast or group on the KNX.
•
No: The addressed status of the switch state of a ballast or group is not actively sent on the KNX.
The object value is only sent on request with the ballast or group number.
Enable Group object
"Status brightness addressed"
Options:
Linked group object:
•
Yes: The coded group object Status brightness addressed is enabled. This coded 2-byte group object
(address plus status) sends the switching state of a ballast or group on the KNX.
•
No: The addressed status of the brightness value of a ballast or group is not actively sent on the KNX.
The object value is only sent on request with the ballast or group number.
56 2CDC507164D0201 | DG/S x.64.1.1
Value for different brightness
states at DALI output
Options: Average brightness of all lamps in the output
Highest brightness of all lamps in the output
Lowest brightness of all lamps in the output
This parameter defines the status to be sent if DALI devices with different states are present on the
output.
•
Average brightness of all lamps in the output: The average brightness of all the DALI devices is
sent on the KNX as the status of the DALI output.
•
Highest brightness of all lamps in the output: The highest brightness value of the DALI devices
is sent on the KNX as the status of the DALI output.
•
Lowest brightness of all lamps on the output: The lowest brightness value of the DALI devices
is sent on the KNX as the status of the DALI output.
Yes
No
Yes
No
Status switch addressed
Status brightness addressed