Commissioning - ABB i-bus KNX Product Manual

®
ABB i-bus KNX

Commissioning

3 Commissioning
The application programs used to parametrize the KNX DALI gateway are:
DG/S 1.64.1.1:
DG/S 2.64.1.1:
and the Engineering Tool Software ETS, version 4.2.0, 5.5.3 or later.
The applications are in ETS under ABB/Illumination/DALI/.
The following work must be carried out:
•
Assignment of the physical KNX device address (ETS)
•
Optional re-addressing of DALI devices (ABB i-bus
•
Assignment of the DALI devices to groups represented in the KNX.
The ABB i-bus
•
Parametrization of the DG/S (ETS)
Parametrization requires a PC or laptop with ETS4 or higher and a connection to the KNX,
e.g. via a USB or IP interface.
The DG/S assigns the first free DALI address to each connected DALI device without one. This automatic
addressing can be prevented using a parameter in ETS, see General parameter window, p. 28. DALI
devices can also be readdressed or assigned to any group with the ABB i-bus
case the DALI devices must already have a DALI address (0...63).
Note
The gateway can control the lamps that have a DALI address or are assigned to a group or scene.
DALI lamps can also be controlled in broadcast (all together). This requires no DALI address.
Note
With ETS 5, the gateways support programming with long frames to permit rapid data transfer between
ETS and the gateway. This cuts programming time by more than half, particularly in the case of a full
download. Corresponding system devices such as line couplers and interfaces must also support long
frames. We recommend the ABB LK/S 4.2 Line Coupler, IPR/S 3.1.1 IP Router or IP Interface
IPS/S 3.1.1 or later.
DALI Basic 1f/1...
DALI Basic 2f/1...
®
Tool is used for this.
®
Tool)
®
Tool without ETS, in which
DG/S x.64.1.1 | 2CDC507164D0201 23