ABB i-bus KNX Product Manual page 143

®
ABB i-bus KNX
Commissioning
Parameter settings
Options:
This parameter defines whether the group/ballast settings are taken from the template or individually set.
•
•
The individual parameter windows and parameters are identical to those in the templates, therefore the
individual parameters are not covered separately here – please see X Fault template (group x/ballast x)
parameter window, p. 95.
Note
The minimal dimming value and maximum brightness value (dimming thresholds) set for the DALI
devices in the Ballast x and Group x parameter windows apply as basic settings for the ballast.
Certain of these thresholds are stored in the ballast and also apply to the setting in the Fault
parameter window.
Individual
Apply from template
Individual: The group/ballast is individually parametrized. Corresponding parameters for the
group/ballast are shown. The content of the individual parameters is the same as that in the Fault
template parameters.
Apply from template: The group/ballast takes its parameters from the Fault template.
DG/S x.64.1.1 | 2CDC507164D0201 141