ABB i-bus KNX Product Manual page 102

®
ABB i-bus KNX
Commissioning
Enable Group object
"Lamp/ballast fault"
Options:
Linked group object:
This group object indicates a fault in the ballast or group. The fault type (lamp or ballast) is parametrizable.
•
Yes: The group object is enabled.
•
No: The group object is not enabled.
The following parameter is used to select the fault type that the Fault group object will indicate.
100 2CDC507164D0201 | DG/S x.64.1.1
Yes
No
Selection of Yes option:
Dependent parameters:
Content of Group object
Options: Lamp/ballast fault
Lamp fault
Ballast fault
This parameter determines which fault is provided on the Fault group object.
•
Lamp fault: The Fault group object sends information on the KNX indicating whether the
ballast/a group ballast has a lamp fault.
•
Ballast fault: The Fault group object sends information on the KNX indicating whether the
ballast/a group ballast has a ballast fault.
•
Lamp or ballast fault: The Fault group object sends information on the KNX indicating whether
the ballast/a group ballast has a lamp or ballast fault.
Lamp/ballast fault