Lighting Converter/Emergency Light X Parameter Window - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
3.2.6.2 X lighting converter/Emergency light x parameter window
Settings for an emergency lighting converter test on emergency lights with individual batteries are made in
this window. Tests are automatically triggered by the converter, or by a higher level controller via the KNX
and the gateway. The tests themselves are run by the converter. The converter sends the test results on
the DALI. The gateway sends them to the KNX, where they can be stored and documented by a controller.
Parameter settings
Options:
This parameter defines whether the emergency lighting converter settings are taken from the template or
set for each converter individually.
•
•
The individual parameter windows and parameters are identical to those in the templates, therefore the
individual parameters are not covered separately here – please see X lighting converter/Emergency light
template parameter window, p. 155.
Individual
Apply from template
Individual: The emergency lighting converter is individually parametrized. Corresponding parameters
for the converter are shown. The individual parameters are the same as on the emergency light
template, but only apply to the emergency lighting converter Emergency light x.
Apply from template: The emergency lighting converter takes its parameters from the Emergency
light template.
DG/S x.64.1.1 | 2CDC507164D0201 165