®
ABB i-bus
KNX
Commissioning
Note
Note that any ballast or group number can be used as a master. Programmers must ensure that the
group or ballast is correctly connected to the output.
If a ballast is assigned to a DALI group, it cannot be individually controlled and therefore nor can it be
used as a master. In this case, the corresponding DALI group must be selected as the master.
Parameter settings
Options:
This parameter defines whether the group/ballast settings are taken from the template or individually set.
•
•
The individual parameter windows and parameters are identical to those in the templates, therefore the
individual parameters are not covered separately here – please see X Slave template (group x/ballast x)
parameter window, p. 112.
146 2CDC507164D0201 | DG/S x.64.1.1
Individual
Apply from template
Individual: The group/ballast is individually parametrized. Corresponding parameters for the
group/ballast are shown. The content of the individual parameters is the same as that in the group
x/ballast x template parameters.
Apply from template: The group/ballast takes its parameters from the group x/ballast x template.