Output: Fault Parameter Window - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
3.2.3.2 X Output: Fault parameter window
This parameter window is used to define how output X reacts in the event of a fault. With the
DG/S 2.64.1.1, the two DALI outputs are mutually independent and can each be parametrized differently.
The status response of the individual ballast and group can be set in the respective ballast/group in the
Group x fault and Ballast x fault parameter windows. The ballast/group template window does not apply to
the output.
Note
A ballast with a fault (ballast fault or lamp fault) receives OFF status and a brightness value of 0.
DG/S x.64.1.1 | 2CDC507164D0201 57