Samsung OfficeServ 7200 Programming Manual page 99

CHAPTER 2. MMC Programming
[300] CUSTOMER ON/OFF PER STATION
Allows the following features to be enabled/disabled on a per-station basis.
No Option
00 ACCESS DIAL
01 MICROPHONE
02 OFF-HOOK RING
03 SMDR PRINT
04 TGR ADV.TONE
05 VMAA FORWARD
07 NGT PASSCODE
08 INTRCOM SMDR
09 FWD DELAY USE
11 FORWARD OVRD
12 RECL TO OPER
13 SLT LP OPEN
15 CID TO SLT
22 NO RCL FLASH
Samsung Business Communications
Default
ON Determines whether a user can select a trunk or trunk
group by dialling its directory number (DN). This selec-
tion should be turned off when using LCR.
ON Allows phones to be used in speakerphone mode.
ON Will allow a short burst of ring tone to indicate another call.
ON When the station is set for no Trunk Line calls to and
from this station, the station will not print on SMDR.
This includes transferred calls or calls picked up from
hold or park.
ON When this feature is set to ON, a warning tone will be
heard each time LCR advances to the next route.
ON This feature selects whether Trunk Line calls can be
forwarded to voice mail: ON, permits forward to voice
mail; OFF, no forward to voice mail.
ON When ON, the steps verifying the ring plan passcode
will be added in Ring Plan change.
OFF When the station is set to OFF, the station will not print
intercom calls on SMDR.
OFF When ON, calls will overflow to the Forward No Answer
destination when the Forward No Answer timer expires
even when the Forward No Answer feature is not acti-
vated at the called party extension.
OFF When set to ON and the station calls another station
which has forwarding set, the call will not forward.
OFF When the station is set to ON, if the station transfers a
call and the destination doesn't answer, the call will
recall to the operator instead of the station.
OFF When ON, SLI port receives real disconnect signal in-
stead of busy or error tone. (VMAA or DATA ports al-
ways receive real disconnect signal.)
OFF When a MIS card is installed and this option is set to
ON, the system will provide the CID signal to SLTs.
OFF When the hook switch is flashed or the flash key is
pressed, a recall signal will not be sent to the system.
OfficServ 7200 Programming Guide
Description
2-68