Samsung OfficeServ 7200 Programming Manual page 203

CHAPTER 2. MMC Programming
[603] ASSIGN TRUNK GROUP
Allows the assignment of trunks to a specific trunk group or to several trunk groups. This is
useful in the programming of LCR when more than one trunk is to be in several dialling
plans. There are two different modes of operation: (1) sequential and (2) distribute. There
are 30 programmable trunk groups with up to 99 members per group.
DEFAULT DATA
ALL LOOP/ISDN TRUNKS: 9
ALL TIE TRUNKS: 801
ALL VOIP NETWORKING TRUNKS: 803
ALL VOIP H.323 TRUNKS: 804
ALL VOIP SIP TRUNKS: 805
ACTION
1. Press Transfer button and enter 603.
Display shows:
2. Enter valid trunk group (e.g., 9)
OR
Press Volume button to make selection and press
Right Soft button to advance cursor.
3. Press Right Soft button to change mode.
OR
Press Volume button to change mode to member.
4. Press Right Soft button to move cursor to number
of member and enter valid member number
(e.g., 05) via dial keypad.
OR
Press Volume button to make selection and press
Right Soft button to move cursor.
Samsung Business Communications
One trunk can appear in more than one trunk group. If necessary, delete the trunk
member from other groups to prevent accidental access.
OfficServ 7200 Programming Guide
DISPLAY
[9] TRK GROUP
MODE:SEQUENTIAL
[9] TRK GROUP
MODE:SEQUENTIAL
[9] TRK GROUP
MEMBER 01:NONE
[9] TRK GROUP
MEMBER 05:NONE
2-172