Samsung OfficeServ 7200 Programming Manual page 150

CHAPTER 2. MMC Programming
[419] BRI OPTIONS
Assigns several options on a per-BRI basis. There are different options depending on
whether the BRI is programmed as a trunk or station in MMC 423.
OPTIONS FOR BRI PORTS PROGRAMMED AS TRUNKS
No Option
0 CHANNEL ANY
1 BRI MODE
P-P NOR
P-P DID
P-M NOR
P-M MSN
2 DLSEND
ENBLOCK
OVERLAP
3 CLIP TABLE
4 NB TYPE
UNKNOWN
INT.NAT
NATIONAL
NETWORK
SUBSCRIB
EXTEN
ABBREV
Samsung Business Communications
When this option is set to YES, the system will place calls on any free
channel of that BRI if the channel chosen by the user is busy. If set to
NO, they will receive a busy signal if they attempt to access a busy
channel even if the other channel on that BRI is free.
BRI access mode select.
Point to Point NORmal. This operates like a standard telephone line with
one CO number per channel and ring according to MMC 406.
Point to Point Direct Inward Dial. This operates in a similar manner to an
analogue DID circuit with multiple CO numbers pointed to a single
channel and translated within the system (MMC714) to a single device.
Point to Multi-point NORmal. This type of circuit operates in a similar
manner to P-P NORmal but allows multiple devices to be attached to the
circuit. Ringing is defined in MMC 406.
Point to Multi-point MSN. This setting is used when the line uses the
MSN supplementary service. Ringing is defined in MMC 421.
BRI dial sending mode select.
Digits will be collected and sent in a single block similar to a cellphone.
Digits will be sent as they are dialled by the user.
Used to select the Calling Party Number to send to the network. If
NONE, MMC405 TRUNK CO TEL NUMBER is sent to the network; oth-
erwise, the Calling Party Number entry in MMC 323 corresponding with
the selected number is sent to the network.
Used to select the type of the Calling Party Number to send to the net-
work.
Unknown number
International number
National number
Network specific number
Subscriber number
Local number
Abbreviated number
OfficServ 7200 Programming Guide
Description
2-119