Samsung OfficeServ 7200 Programming Manual page 388

CHAPTER 2. MMC Programming
No Code
MNF--
64 MNF01
65 MNF02
66 MNF03
67 MNF04
68 MNF05
69 MNF06
70 MNF07
71 MNF08
72 MNF09
73 MNF10
74 MNF11
75 MNF12
76 MNF13
77 MNF14
78 MNF15
79 MNF16
Samsung Business Communications
Alarm Name
Minor Error Minor Fault with Alarm Buffer saving
Card Out A circuit card mounted in a universal slot has been re-
moved from service or is not recognized by the system
Alarm Data = Cabinet, Slot (Cx-Syy)
Card In A circuit card mounted in a universal slot has been re-
turned to service.
Alarm Data = Cabinet, Slot (Cx-Syy)
IPC Error Inter-processor communication error has occurred.
Alarm Data = Cabinet-Slot (Cx-Syy)
Trunk Fault Out of service trunk detected via loop detect. Internal
CODEC test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Trunk Recovery Out of service trunk detected via loop detected as out of
service is now operational.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Trunk Discon- Out of service trunk detected via seizure of trunk. Exter-
nect nal seizure test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
Trunk Connect Out of service trunk recovered via seizure of trunk. Ex-
ternal seizure test.
Alarm Data = Cabinet, Slot, Port (Cx-Syy-Pzz)
SIO TxQ Over SIO Tx Queue full error has occurred in the MCP2.
Alarm Data = SIO number (SIO: x)
SIO TxQ Under SIO Tx Queue under error has occurred in the MCP2.
Alarm Data = SIO number (SIO: x)
E1 Out Of Srv E1 Digital line status has been changed to out of ser-
vice.
Alarm Data = Cabinet, Slot (Cx-Syy)
E1 In Service E1 Digital line has been restored to normal service.
Alarm Data = Cabinet, Slot (Cx-Syy)
SIO Out IO port has lost DTR
Alarm Data = SIO number (SIO: x)
SIO In IO port has regained DTR.
Alarm Data = SIO 1 through 6
TODC Error Time of Day Clock in the MCP2 has erred.
TSW Over Alarm The TSW has been requested to exceed the capacity of
available time slots. Maximum 192 per cabinet.
Alarm Data = Cabinet, Slot (Cx-Syy)
PSU Alarm There are more ports than can be supported in a
cabinet and more power is required.
Alarm Data = Cabinet, Slot (Cx-Syy)
OfficServ 7200 Programming Guide
Definition
2-357