Samsung OfficeServ 7200 Programming Manual page 346

CHAPTER 2. MMC Programming
[834] H.323 OPTIONS
This MMC provides various VoIP support options. The options set in this MMC apply sys-
tem wide.
No Parameter
00 GATEWAY CALL ID
01 H.323 FAST SETUP
02 CALLER ID TYPE
06 TUNNELING
07 DEFAULT DIL NO
11 CODEC AUTO NEGO
14 SIGNAL PORT
17 SEND CLIP TABLE
18 INCOMING MODE
19 ALLOW GW CHECK
20 CLIR WITH NUMBER
21 USE OVERLAP DIAL
Samsung Business Communications
Description
Numeric identifier for system (up to 12 digits).
Enables or disables the H.323 Fast Start call setup
method.
This option controls the calling party identification
type. There are 3 possible selections :
0 GWID: shows the gateway call ID.
1 ANI: shows the calling station number
2 IP: shows the calling H.323 gateway IP ad-
dress.
Enables or disables the need for additional chan-
nels using H.245 signalling. Tunneling allows use
of the H.245 signal channel with the Q.931 chan-
nel.
This allows programming of the default direct-in-
line number when digits are missing or incorrect on
an inbound call.
Enables or disables Auto CODEC Negotiation
when the MGI is used as an H.323 gateway.
Indicate the port number for H.323 signalling and
sets a range of numbers allowed by firewall
equipment. The common and default IP path or
port used is 10000.
Refers to SEND CLI NUMBER (MMC 323), which
provides calling party identification when using the
MGI as a H.323 gateway. This provides station ID
of the calling station. A single-digit value corre-
sponding with the desired table in MMC 323
should be entered here. This is only used when
MMC 405 value is null.
This option selects how incoming calls are routed
when the MGI is used as a H.323 gateway.
0 FOLLOW TRUNK RING: Follows MMC 406
1 FOLLOW DID TRANS: Follows MMC 714
2 FOLLOW INCOM DGT: Follows MMC 724
When using a gatekeeper, this permits the H.323
gateway to check for gatekeeper presence.
When this option is enabled, the CLIP number is
sent to the network even if the CLIP restriction flag
is set.
Enables use of overlap dialling
OfficServ 7200 Programming Guide
Default
1234
ENABLE
ANI
ENABLE
500
ON
10000
1
FOLLOW
DID TRANS
DISABLE
DISABLE
ENBLOC
2-315