Samsung OfficeServ 7200 Programming Manual page 262

CHAPTER 2. MMC Programming
[724] DIAL NUMBERING PLAN
This MMC allows the technician to change directory numbers for stations, trunks, station
groups, trunk groups and feature access codes. The system can be pre-programmed with
default 3- or 4-digit numbering for stations, station groups and trunk numbers depending
on the position of the DIP switches on the MCP card. There is an error message provided to
prevent the accidental duplication of a directory number or feature access code.
No Type of Dial No
00 STN DIAL NO.
01 TRK DIAL NO.
02 AA/VD DIAL NO
03 MISC DIAL NO.
04 STNG DIAL
NUMBER
05 TRKG DIAL
NUMBER
06 FEAT DIAL NUMBER
07 S0 STN DIAL NO.
09 NTWK LCR DIAL NO
Samsung Business Communications
This is where station directory numbers are changed or assigned.
Default: 201-2xx, 3xx(last 319) or 2001-2xxx
This is where trunk directory numbers are changed or assigned.
Default: 701-7xx or 7001-7xxx
Not used
This is where directory numbers for relays, MOH ports and the
alarm sensor are changed or assigned.
Default: Internal MOH: 3761
External MOH: 3762-3763
External PAGE: 3752-3753
Common Bell: 3991
Loud Bell: 3995
This is where station group numbers are changed or assigned.
Default: 500-5xx or 5001-5xxx
This is where trunk group numbers are changed or assigned.
Default: The first is 9 or 0, 800-828
This is where feature access codes are changed or assigned. Dial-
ling codes are entered via the dial keypad by pressing a number
the required number of times to select the feature. For example, for
OHVA, the number 6 would be pressed three times.
NOTE: Remember that this program applies system-wide.
This is where directory numbers for BRI station ports are changed
or assigned.
Default: 8701-8748
This is where additional LCR access codes are entered if two or
more OfficeServ 7200 systems are networked together.
Default: NONE
OfficServ 7200 Programming Guide
Description
2-231