Ip Settings - Honeywell Notifier NFW-100X Manual

Programming

POTS Line (X)
If telephone lines are connected to the IPOTS-COM board at J4 (Line 1) and J5 (Line 2), their settings can be configured by pressing 1
or 2, respectively. Pressing 1 or 2 will display the following screen. The programming options for Line 1 and Line 2 are identical.
Phone Line (X) Enable
POTS LINE X
1=ENABLED
2=TYPE
3=SUPERVISED
POTS Line X Screen
Type
To select the type, press 2 while viewing the POTS Line (X) Screen #1. The following screen will be displayed:
Press 1 to select Touchtone dialing, 2 to select Rotary dialing with a make/break ratio of 67/33 or 3 to select Rotary dialing with a
make/break ratio of 60/40.
Supervised Phone Line
POTS LINE X
1=ENABLED
2=TYPE
3=SUPERVISED
POTS Line X Screen
table on page 49 for permissible settings.

Gains
POTS SETTINGS
1=LINE 1
2=LINE 2
3=GAINS
POTS Settings Screen
The Gains value can be adjusted for when the telephones lines are in use for Dialing and Reporting. Press 1 or 2 to change these values,
respectively. The following screen will display for both options.
Press 1 for Low, 2 for Normal, and 3 for High. After the Gains value has been selected, the display will return to the Gains Screen.

IP Settings

COMMUNICATOR
1=INSTALLED
2=POTS SETTINGS
3=IP SETTINGS
Communicator Screen #1
82
To enable the phone line, press 1 while viewing the POTS Line (X) Screen #1 to change the display to
YES
Enabled Yes. Each press of the 1 key will cause the display to toggle between Enabled Yes and Enabled No.
YES
TYPE
1=TOUCHTONE
2=ROTARY 67/33
3=ROTARY 60/40
The Supervised Phone Line feature allows the user to disable the supervision of Phone Lines when using an
YES
alternate means of secondary transmission path. The factory default setting is Phone Line (X) supervised.
Supervision must be set to Yes if the selected transmission path is POTS.
YES
Pressing 1 for Supervision while viewing the POTS Line (X) Screen #2 will change the screen to read
Supervision No. Each press of the 1 key will toggle the option between Supervise Yes and No. Refer to the
The Gains value is the telephone's transmitting "volume control". To adjust the settings, press 3 while view-
ing the POTS Settings screen. The following screen will be displayed:
The IP settings configure the system when the central station will be contacted over the internet. The fol-
YES lowing screens allow the user to enter the device addresses needed for communication. Pressing 3 while
viewing the Communicator Screen #1 will display the following.
IP SETTINGS
1=DHCP ENABLED
2=STATIC SETTINGS
3=ENTER PIN
IP Settings Screen #1
POTS LINE X
1=ENABLED YES
2=TYPE TOUCHTONE
3=SUPERVISED YES
POTS Line X Screen
Type Settings Screen
GAINS
1=DIALING NORM
2=REPORTING NORM
Gains Screen
GAINS
1=LOW
2=NORMAL
3=HIGH
Gains Screen
NO 1=ETHERNET FAULT 01
2=CELLULAR FAULT 01
NFW-100X Manual — P/N LS10131-001NF-E:C 7/25/2018
Master Programming Level
IP SETTINGS
IP Settings Screen #2