5: N-Ann-I/O Led Driver Module - Honeywell Notifier RP-2001 Instruction Manual

Installation

Setting Printer Options
Refer to the documentation supplied with the PRN-6 printer for instructions on using the printer
menu controls. Set the printer options (under the menu area) as shown in the following table:
2.7.5 N-ANN-I/O LED Driver Module
The N-ANN-I/O is an LED driver module that can be used in a wide variety of applications,
including as an interface with most customized graphic annunciators. The N-ANN-I/O can drive up
to 40 LEDs. The following sections describe hardware installation. Refer to the section
titled"ANN-BUS" on page 66 for programming information.
42
Option Setting
Font HS Draft
LPI
ESC Character
Bidirectional Copy
CG-TAB Graphic
Country E-US ASCII
Auto CR
Color Option Not Installed
Formien
Lines 6LPI=60
Standard Exec 10.5
Table 2.3 PRN-6 Setup Options
Option
CPI
6 LPI Skip
ESC Emulate
ON I/O
Buffer
Serial
OFF Baud
Format
Protocol
Character Set
SI.Zero
Auto LF
PAPER
BIN 1
BIN 2
SINGLE
PUSH TRA
PULL TRA
PAP ROLL
RP-2001 Series Manual — P/N 52985:D5 1/26/2017
ANN-BUS Devices
Setting
10CPI
0.5
Epson FX-850
40K
9600 or 2400
7 Bit, Even, 1 Stop
XON/XOFF
Standard
On
On
12/72"
12/72"
12/72"
12/72"
12/72"
12/72"