Control Card Dip Switch Settings - Honeywell MAXPRO-Net Hardware Installation Manual

11.7 CONTROL CARD DIP SWITCH SETTINGS

The HMX128 controller card (the left-most card when viewing the front of the subrack)
has four 8-way DIP switches. The upper switches (SW1 and SW2) control the Pan/Tilt
protocol while the lower two (SW3 and SW4) control the subrack ID, baud rate, and
alarm detection mode.
The upper switch (SW1) controls Pan/Tilt protocol for Group A (ports 1 to 4 on rear of
HMX128 card). The lower switch (SW2) controls Pan/Tilt protocol for Group B (ports 5 to
8 on rear of MX-128 card).
Below are the DIP Switch settings for SW1 and SW2.
1 2 3
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON
OFF ON ON
ON ON ON
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
ON OFF ON
OFF ON ON
ON ON ON
OFF OFF OFF
ON OFF OFF
OFF ON OFF
ON ON OFF
OFF OFF ON
1 MX302 firmware, version 2.06 or higher.
Rev. C
4 5 6
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
ON OFF OFF
OFF ON OFF
OFF ON OFF
OFF ON OFF
OFF ON OFF
OFF ON OFF
11-4
7 8
OFF OFF Diamond FastScan/SmartScan
OFF OFF Diamond SmartScan III/KD6
OFF OFF MAXPRO RS-485
OFF OFF MAXPRO AF-485
OFF OFF Panasonic
OFF OFF Pelco AD Format
OFF OFF Vicon Std
OFF OFF Vicon Extended
OFF OFF Star Micronics
OFF OFF VIDEV
OFF OFF VCL
OFF OFF Pelco P Format
OFF OFF JVC
OFF OFF Speeddome
OFF OFF Kalatel
OFF OFF Baxall 7000 Series
OFF OFF Panasonic 850 Series 19K2 Baud
OFF OFF Panasonic 850 Series 9600 Baud
OFF OFF Forward Vision MIC1-300
OFF OFF Pelco Coaxitron
OFF OFF VST1
Protocol
HMXMU001018
10/06