Table of Contents
Advertisement
Device Description
SONY/SANYO GENERIC
MITSUBISHI GENERIC
PANASONIC GENERIC
SONY YS-DX316P MULTIPLEXER
PHILIPS LTC3991
SANYO SRC-850/DSR-M800
Rev. C
Resistive Mode Device Selection
(SW2, 8-way DIP Switch)
Firmware
Version
V1.00
V1.00
V1.00
V1.01
V1.03
V2.08
SW-5 to SW-8 must all be set to OFF
NOTE: The Sony YS-DX316P multiplexer has 2 resistive
ladder inputs. Therefore 2 outputs from the RD494 are
required to control a single multiplexer.
NOTE: Other device selections are not defined and will
return a FATAL-ERROR display of (2)...Device Not Found.
NOTE: Honeywell makes no representation and offers
no warranties as to the accuracy and/or suitability of third
party protocols and command formats. Such protocols
and command formats are based upon information
supplied to Honeywell by the third party
manufacturers/suppliers at the time of implementation.
NOTE:
RS-232 operating mode is supported in the
RD494 V2.04 firmware revision onwards.
7.16-4
SW-1
SW-2
SW-3
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
SW-4
OFF
OFF
OFF
OFF
OFF
OFF
HMXMU001018
10/06
Advertisement
Table of Contents
