Table of Contents
Advertisement
7.17 HEGS5300 Keyboard
7.17.1
Setup Mode
HEGS5300 (and version 2 and above RD-530 keyboards) are setup using the keyboard
keys. There are 3 user-defined settings. These are:
•
•
1 stop bit, even parity).
•
joystick. The default is a range of 5 speeds (0=STOP to 5=Maximum speed). The
alternative is a range of 26. As before 0=STOP, but the speeds generated are from A
(slowest) through to Z (fastest. Speed Z is equivalent to speed 5, in that it is
generated when the joystick is at its maximum pan or tilt position.
To enter SETUP MODE, hold down the <MENU> key or the ⇑ key (to the right-hand-
side of the LCD) as the keyboard is powered up.
Once in setup mode, the LCD prompts the user to enter the required information using
the numeric keypad. Pressing the <ENTER> key or the ⇓ key moves to the next stage.
Pressing the ⇑ key goes back to the previous setup screen.
When the keyboard ID, baud rate and joystick speed range has been entered, the final
setup stage will store the settings and the joystick reference position. The keyboard
should be flat on the desk when pressing the <ENTER> key at this final stage to ensure
the joystick is zeroed. Setup information is stored in non-volatile memory so the settings
will be retained if the keyboard is unplugged.
Rev. C
Keyboard ID – valid IDs 1 to 99. (Default = ID 1).
Baud Rate – 19K2 or 9600. (Default = 19K2. Data format is fixed at 7 data bits,
Joystick speed range – There are 2 ranges of pan/tilt speeds from the analogue
Note: When some custom keyboard overlays are fitted
to keyboards, the MENU key may be located in a different
position. Therefore using the
always a preferred option.
Note: The ⇑ key option is only available on keyboards
with firmware revisions 2.02 and above.
⇑
key next to the LCD is
7.17-1
HMXMU001018
10/06
Advertisement
Table of Contents
