Table of Contents
Advertisement
5.4.2
PATCH232 Test Program, Continued
From MASTER to SLAVE Window:
This window displays all data received from COM1 (Master) and at the same time the
data is re-transmitted to the Slave via COM2. Any data manually sent from PATCH232 to
the Slave will also be displayed in this window.
From SLAVE to MASTER Window
This window displays all data received from COM2 (Slave) and at the same time re-
transmits the data to the Master via COM1. Any data sent from PATCH232 to the Master
will also be displayed in this window.
Comms Status Window: This window displays the current comms' and the recorder
status.
Commands
<ESC>
<M>
<S>
<R>
Internal Diagnostics
Additional Diagnostics are available from MaxMon. (See MaxMon Diagnostics Utility.)
The MaxMon Utility can display the following details simultaneously at runtime:
•
•
•
•
•
•
Rev. C
To return to DOS.
Send command to MASTER. Pressing the 'M' key enables you to enter a
string or command that will be sent to the MASTER. For example, you could
send to the MAXPRO-Net
command (*1Z) which would cause the MAXPRO-Net
BOOT and update all subracks.
Send command to SLAVE. Pressing the 'S' key enables you to enter a
command that is sent to the SLAVE.
Recorder log ON/OFF. Pressing the 'R' key toggles the record status on and
off. When the record mode is enabled, all data received is time and date
stamped and recorded to files on the hard disk. Two files are created
MASTER.LOG that contains all data received from the MASTER (COM1),
and SLAVE.LOG that contains all data received from the SLAVE (COM2). If
the files already exist, PATCH232 will append them.
Received data,
Transmitted data
Macro Trails
Macro Execution sequence
Video Source Control Selection
Video Switch selections.
®
Control Computer, the Subrack #1 reset
5-9
®
software to WARM
HMXMU01018
10/06
Advertisement
Table of Contents
