Integration Of Mx18 System Controller With Maxpro-Net And Videoblox Matrix Chassis - Honeywell MAXPRO-Net Hardware Installation Manual

7.3.1 Integration of MX18 System Controller with MAXPRO-Net and VideoBloX Matrix
Chassis
SLAVE MAXPRONET SERVER
RS232
DB9-RJ Connector
Provided by Honeywell
HVBMATPIT
MASTER RS232
DB9
Pin 3, RX
Pin 2, TX
Pin 5, GND
MASTER
HVBMATPIT
RS232
SLAVE
RS422
HVBMATPIT DIP SWITCH SETTINGS
RS422
WIRING
PIT COMBO
Pin 1 -- Pin 4
Pin 2 -- Pin 3
Pin 3 -- Pin 2
Pin 4 -- Pin 1
Pin 5 -- Pin 5
Pin 6 -- Pin 6
Pin 7 -- Pin 7
Pin 8 -- Pin 8
Pin 9 -- Pin 9
Note: If Pins 6 and 9 are connected as shown above,
the HVBM ATPIT receives power from the HVB422FT16.
Do not attach an additional power supply to the
HVBMATPIT.
Rev. C
COM 7
COM 1 COM 2
MX18
MX18
HMX1600
S1 S2 S3
1 - ON 1 - OF F 1 - OF F
2 - ON 2 - OF F 2 - OF F
S1 set to Bossware input protocol at 19.2KB
3 - OF F 3 - OF F 3 - ON
S3 set to MAX-1000 Output protocol, reverse direction at 19.2KB
4 - OF F 4 - OF F 4 - OFF
5 - OF F 5 - ON
5 - OF F
6 - OF F 6 - OF F 6 - OFF
7 - OF F 7 - OFF
7 - OF F
8 - ON 8 - OF F 8 - ON
HVB422FT16
MASTER MAXPRONET SERVER
MAXPRO-Net
COM 1 - 9 DB9
COM 8
Pin 2, RX
Pin 3, TX
Pin 5, GND
Coiled Cable Supplied w/Ultrakey
(P/N 849518-0306)
To Matrix Switch Comms
VideoBloX Chassis
Set to Slave pin-out
DIP Switch S1
1 - On
2 - Off
3 - Off
4 - On
7.3-5
COM 1
COM 2
COM 7
RS232
Ultrakey
Keyboard
DATA
RS422
Protocol 1
RS422
Protocol 2
HMXMU001018
COM 8
10/06