Table of Contents
Advertisement
4.1
GENERAL REQUIREMENTS
•
•
•
•
•
•
•
4.1.1
More Complex Faults
•
•
•
•
•
unit)
4.2
ON-SITE EQUIPMENT
In most installations some form of communication is required from the camera to the
control room monitors. VHF or UHF hand held radios best suit this requirement. Mobile
telephones sometimes have application in this area. Adjustments such as focus, iris and
camera position can usually be set in this manner. Back focus can also be done "in situ"
although better results are usually obtained by doing this under controlled conditions in
the workshop.
Rev. C
CHAPTER 4:
TEST EQUIPMENT
BNC patch cables and joiners
Test monitor (preferably portable)
Test video cord 3 pin IDC to BNC
Digital multimeter
75 ohm termination
BNC T adapter
RS-232 indicator modules and Patch Cords
20 MHz Oscilloscope
Video generator
Test program PATCH232.EXE (Supplied on the MAXTOOLS disk)
Null modem cables and adapters
IBM compatible computer with at least two serial ports (Preferably a portable
4-1
HMXMU01018
10/06
Advertisement
Table of Contents
