Honeywell MAXPRO-Net Hardware Installation Manual page 33

5.3 MACRO ERRORS, CONTINUED
30 String variable command format error
31 String variable range error
32 Unknown evaluate command for string
33 Too many nested do-while loops
34 Format error in do-while loop
35 Maximum loop cycles has been exceeded
36 Keyboard priority range error
37 Invalid keyboard identity for macro numeric input command
38 Invalid destination for keyboard macro numeric input command
39 Too many digits requested for keyboard macro numeric input
40 Invalid scan clear command
41 No dynamic macro timer available
42 User flag range error (0
43 Keyboard operator range error (0
44 User defined character range error, in direct comm port writes
45 Undefined comm port number, in direct comm port writes
46 Internal change network source
47 Internal change network source node command format error
48 Scan sequence entry number is out-of-range i.e.: greater than (99)
49 Error in command format received from a subrack/keyboard
50 Parity error in received data from a subrack/ keyboard
51 Range error in Blank Channel command (valid 0 - 3 only)
52 Unknown Special WORD command. eg <WARM-BOOT> etc.
53 Other errors detected during Cold/Warm Boot. Check ERRORLOG.
Rev. C
Macro Error Definition Table
8 only)
100 only)
5-5 HMXMU01018
10/06